进口工程塑料气动隔膜泵

进口工程塑料气动隔膜泵

参考价: 面议

具体成交价以合同协议为准
2024-09-06 07:18:13
181
产品属性
关闭
深圳市凯士比阀门有限公司

深圳市凯士比阀门有限公司

免费会员
收藏

组合推荐相似产品

产品简介

进口工程塑料气动隔膜泵是目前国际市场颖的一种泵,对于各种腐蚀性液体,带颗粒、高粘度、易挥发、易燃、易爆、剧毒的液体、陶瓷釉浆、果浆、胶水、油轮仓库油回收、临时倒罐等液体均能予以抽光吸尽

详细介绍

进口工程塑料气动隔膜泵是目前国际市场颖的一种泵,对于各种腐蚀性液体,带颗粒、高粘度、易挥发、易燃、易爆、剧毒的液体、陶瓷釉浆、果浆、胶水、油轮仓库油回收、临时倒罐等液体均能予以抽光吸尽。德国汉克(HANK)隔膜泵泵体过流部件材质采用不锈钢、铝合金、铸铁、工程塑料,隔膜根据不同液体分别采用丁晴橡胶、氟橡胶、氯丁橡胶、聚四氟乙烯及聚全氟乙丙烯(F46)。
产品特点
1、无轴封、无泄漏、流道宽敞,所以输送含颗粒,高粘度(粘度可达1万厘泊),易挥发和腐蚀性介质时,不会造成环境污染和危害人身安全。
2、无旋转部件,通过性能好,允许通过颗粒直径达10mm。液体无剪切流动,泵自身部件磨损小。对输送物损伤小,可输送污泥和生命体如小鱼苗之类。
3、不需灌引水,自吸能力强,吸程高达7m,长时间干呼吸,对泵不损坏。一旦超负荷,泵便会自动停机,负荷恢复正常时,能自动启动运行,具有自我保护功能(电动泵无此功能)。
4、扬程达50m,电动泵达30m,出口压力可达0.6mpa。扬程、流量可通过气阀开度实现无级调节,气压调节在1-7kgf/cm2之间电动泵无此功能,进口需装调节阀控制。
5、可以浸没在介质中工作,无电源通过,安全可靠(电动泵无此性能)。
6、不需电源,更适合易燃、易爆场合的介质输送。
主要用途
1、泵吸花生酱、泡菜、土豆泥、小红肠、果酱苹果浆、巧克力等。
2、泵吸油漆、树胶、颜料。
3、粘合剂和胶水、全部种类可用泵吸取。
4、各种瓦、瓷、砖器及陶器釉浆。
5、油井钻好后,用泵吸沉积物及灌浆。
6、泵吸各种乳剂和填料。
7、泵吸各种污水。
8、用泵为油轮,驳船清仓吸取仓内污水。
9、啤酒花及发酵粉稀浆、糖浆、糖蜜。
10、泵吸矿井、坑道、隧道、选矿、矿渣中的积水。泵吸水泥灌浆及灰浆。
11、各种橡胶浆。
12、各种磨料、腐蚀剂、石油及泥浆、清洗油垢及一般容器。
13、各种剧毒、易燃、易挥发液体。
14、各种强酸、强碱、强腐蚀液体。
15、各种高温液体可耐150℃。
16、作为各种固体液分离设备和前级送压装置。
Engineering plastic pneumatic diaphragm pump is the most innovative of the international market a pump for a variety of corrosive liquids, with particles, high viscosity, volatile, flammable, explosive, highly toxic liquid, ceramic glaze pulp, pulp , Glue, tanker warehouse oil recovery, temporary cans and other liquid can be pumping exhausted. Germany Hank diaphragm pump pump parts of the material used in stainless steel, aluminum, cast iron, engineering plastics, according to different liquids were used Dingqing rubber, fluorine rubber, chloroprene rubber, polytetrafluoroethylene and poly Ethylene propylene (F46).
Features
1, no shaft seal, no leakage, the flow channel is spacious, so the delivery of particles, high viscosity (viscosity up to 10 centipoise), volatile and corrosive media, will not cause environmental pollution and harm personal safety.
2, no rotating parts, through the performance is good, allowing the maximum particle diameter of up to 10mm. Liquid without shear flow, the pump itself wear parts small. Damage to the transport of small, can transport sludge and life such as small fry and the like.
3, without irrigation water, self-priming ability, suction up to 7m, long dry breathing, the pump is not damaged. Once the overload, the pump will automatically shut down, the load back to normal, can automatically start running, with self-protection function (electric pump without this function).
4, up to 50m, electric pump up to 30m, the maximum export pressure up to 0.6mpa. Head, the flow through the valve opening to achieve stepless adjustment, air pressure adjustment between 1-7kgf / cm2 electric pump without this function, import control valve to be installed.
5, can be immersed in the media work, no power through, safe and reliable (electric pump without this performance).
6, no power, more suitable for flammable, explosive media delivery occasions.
The main purpose
1,pumped peanut butter, pickles, mashed potatoes, small red sausage, jam apple pulp, chocolate and so on.
2,pumping paint, gum, paint.
3,adhesive and glue, all kinds of pump can be pumped.
4,all kinds of tile, porcelain, brick and pottery glaze pulp.
5,the oil well after drilling, with pumping sediment and grouting.
6,pumping a variety of emulsions and fillers.
7,pumping a variety of sewage.
8,with the pump for the tanker, barge clearance to absorb the sewage inside the warehouse.
9,hops and baking powder slurry, syrup, molasses.
10,pumping wells, tunnels, tunnels, mineral processing, slag in the water. Pumping cement grouting and mortar.
11,all kinds of rubber pulp.
12,all kinds of abrasives, corrosion agents, oil and mud, cleaning grease and general containers.
13,all kinds of highly toxic, flammable, volatile liquid.
14,all kinds of strong acid, alkali, strong corrosive liquid.
15,a variety of high temperature liquid can withstand up to 150 ℃.

16,as a variety of solid liquid separation equipment and the former pressure device.

德国汉克(HANK)成立于1852年创建于门兴格拉德巴赫(Monchengladbach)是位于德国北莱茵-威斯特州杜塞尔多夫市以西的一座城市。于19世纪50年代初德国经济快速发展,由于德国能源短缺,政府在节能方面加大力度,因此HANK(Trouble Less pump的水泵)公司成立。汉克水泵是以生产高品质、的水泵、测量及控制系统而的跨国性生产企业,在几十个国家拥有子公司及分支机构,公司产品涉及用途:石油、化工、电力、冶金、制药、食品、水处理、市政给排水、天然气、造纸、电子工业、楼宇、机械设备配套等领域。

GERMANY HANK PUMP LIMITED is founded on 1852 in Monchengladbach,which is located at one city in North Rhine in Germany, which is the west of Nordrhein-Westfalen. At the beginning of 1850s, as the rapid development of economic and the shortages of energy in Germany , the government had been in saving energy aspect. On this occasion, HANK Pump (Trouble Less Pump) was established.Hank pump is the world-famous transnational production enterprise,which produces high quality and advanced pump, measurement and control system, and which has its divisions and branches in dozens of countries in the global. The company products user involves the petroleum, the chemical industry, the electric power, the metallurgy, the drugs manufacture, food, the water treatment, the municipal administration to give draining water, the natural gas, the papermaking, the electronics industry, the building, the mechanical device necessary ect..

德国汉克(HANK)水泵的价值理念概括为:责任-远见-创新。我们因自身的责任感、远见及专注于创造的解决方案和理念,而成为的水泵制造商。
The conclusion of the pump concept in German Hank pump is resposibility,foresight,innovation. For ourselves resposibility, foresight and focusing on creating unprecendented solution and concept,our company has become the lead of pump manufacturer in the global.

    
上一篇:QBY衬氟气动隔膜泵的主要产品特点有哪些? 下一篇:无油隔膜真空泵注意事项
热线电话 在线询价
提示

请选择您要拨打的电话: